dl-breadcrumbs__homedl-breadcrumb-item__separatorConfiguration and programmingdl-breadcrumb-item__separatorProgramming with CODESYSdl-breadcrumb-item__separator...dl-breadcrumb-item__separatorCODESYS Development Systemdl-breadcrumb-item__separatorSecuritydl-breadcrumb-item__separatorFAQdl-breadcrumb-item__separatorDisabling User Management
dl-pagination__prev-inactivedl-pagination__prev-activedl-pagination__next-inactivedl-pagination__next-active
Disabling User Managementdl-permalink__symbolPermalink
NOTICE

NOTICE
NOTICE
NOTICE

NOTICE

NOTICE

After disabling the user management, your controller is accessible again for everyone in the network of the controller. Therefore, you should only do this in justified exceptional cases or if the clients used do not support any user management.

For enabling the user management, at least a CODESYS development system V3.5 SP16 is necessary. This means that, in the case of enforced user management which has not been enabled yet, you cannot connect to an older development system.

  1. If the security policy for device user management is set to "Enforced", first set it back to "Optional".

  2. Execute the “Reset Origin Device” command. This deletes the user management and you can then reconnect to the controller without having to enter user credentials. Note: In CODESYS Version 3.5 SP16 Patch 20 and higher, you can exclude the boot application from the delete operation when you execute “Reset Origin Device”.