Side view (open terminal drawn for illustration)

The top view shows the openings for wire and screwdriver

Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15 mm free of insulation at the tip

While erecting the screwdriver, insert it until the stop (requires a little strength)

Screwdriver inserted - terminal open

Strip the wire for 7 mm (and put on wire-end ferrule)

Insert wire into the open terminal

Done

Terminal with wire connected

Insert screwdriver (2.5 x 0.4 ... 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15 mm free of insulation at the tip

While erecting the screwdriver, insert it until the stop (requires a little strength) - terminal is now open

Remove wire from the open terminal

Done