dl-breadcrumbs__homedl-breadcrumb-item__separatorConfiguration and programmingdl-breadcrumb-item__separatorConfiguration in Automation Builderdl-breadcrumb-item__separatorGeneral settingsdl-breadcrumb-item__separator...dl-breadcrumb-item__separatorFirmware identification and updatedl-breadcrumb-item__separatorFirmware installation and update with memory carddl-breadcrumb-item__separatorFirmware and/or application installation and updatedl-breadcrumb-item__separatorExecution of update via memory card
dl-pagination__prev-inactivedl-pagination__prev-activedl-pagination__next-inactivedl-pagination__next-active
Execution of update via memory card

Boot project and firmware update

Precondition: Prepared memory card with boot project and firmware⮫ “Preparation of memory card”.

  1. Switch off the device.

  2. Insert the memory card.

  3. Switch on the device.

    The alternate flashing of the RUN and the ERR LED indicates the running update process.

    At the end of the update process a reboot is executed and the boot project and system firmware is started for the finishing of the update process.

    If RUN LED blinks (ERR LED is off), the update was successful and the display shows “done”.

    If ERR LED blinks (RUN LED is off), the update failed and the display shows “FAIL”.

    The text file “SDCARD.RDY” includes the results of the different updates. If the update fails, the file contains the reasons for the abort. Based on this, further steps can be taken to fix the problem.

  4. Switch off the device.

  5. Remove the memory card.

  6. Switch on the device.

    The system starts with the new boot project and firmware.

Firmware update

Precondition: Prepared memory card with boot project and firmware⮫ “Preparation of memory card”.

  1. Switch off the device.

  2. Insert the memory card.

  3. Switch on the device.

    The alternate flashing of the RUN and the ERR LED indicates the running update process.

    At the end of the update process a reboot is executed and the system firmware is started for the finishing of the update process.

    If RUN LED blinks (ERR LED is off), the update was successful and the display shows done.

    If ERR LED blinks (RUN LED is off), the update failed and the display shows FAIL.

    The text file “SDCARD.RDY” includes the results of the different updates. If the update fails, the file contains the reasons for the abort. Based on this, further steps can be taken to fix the problem.

  4. Switch off the device.

  5. Remove the memory card.

  6. Switch on the device.

    The system starts with the new firmware.